You're question is very generic. Try google or it's best if you can be more specific.

Best bang for you buck. We use it in the shop. it's an excellent multimeter for the price.

1.6amp is perfect. No issues there.

Graphics card motherboards usually have a lot of layers which makes it difficult to de-solder components off them. Even a tiny 201 resistor can be cha...

I use 99% isopropyl. If you can't find 99%, look for 91%. Anything below 91% should not be used for motherboard cleaning as it contains too much water...

Impossible to tell. A lot of times you ca get away with using a similar size diode and hope for the best. Look on eBay and see if you can buy a non wo...

We are working on USBC and HDMI boxes. I will announce it very soon when they are made available.

You may be able to get series x port to work with series x when some modifications. Very few people inquired about the Series s connectors. Maybe we'l...

Surface pros have a low success rate when it comes to motherboard repair especially that no schematics or boardview diagrams are available. That's als...

I'm planning a video about this topic. I will update the post when video is up.

Shipping cost is shown at checkout. Add items to cart and shipping will be calculated based on item size and weight

Chip programmers will be in stock later this week. I'll update the post when when item is available for purchase.

Heat transfer from your soldering iron is limited by the size of the tip. The bigger the tip the more heat transfer. Even if you have your soldering...

Some posts are being deleted so we do not spread confusion about Amtech flux. We are distributors of Original Invented Antech flux and that is the sam...

We have a large shipment of component binders that will arrive later this week and next week. I will update this post when they arrive and available f...