$19.50
In stock
The thermal pad is approximately 7×8 inches. Transparent, Glossy, Thick and can handle up to 500c. Use under a heating plate or when applying hot air so you don’t burn your bench.
This is the best board holder we have worked with by far. The holder has an extra large surface with
Heavy Duty Dual Shaft PCB Board Holder with BGA IC Chip holder. The holder supports 2 boards at once. Size:
Specification: High quality heat resistant pad up to 500 °C. Several Hole cut outs for screws and small parts Built-in
Insert soldering iron inside the heating plate to remove de-solder and solder FPC connectors on flex cables. Heating plate Suitable
This tool is used to Magnetize or Demagnetize just about anything including screw drivers, tweezers and other tools. Insert the
he NorthridgeFix Dual Brush is back in stock. it’s the most used tool on our bench. We now have it
Ultra fine surgical blades used for everything from curing 0.1mm jumper wires to scraping microscopic PCB traces and other tasks
Username or email address *Required
Password *Required
Log in
Lost your password? Remember me
No account yet?
