Main Microsoldering How do you manage to remove the glare

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #10967
    Mohannad Sadeddin
    Participant
      • Topics 1
      • Replies 0
      • Total 1
      • New Member

      Greetings everyone, when I watch Northridgefix videos while under the microscope Alex says “remove the glare” after that the view is much clearer. Can anyone justify what exactly happens and how to remove the glare?

      Thanks alot.

      #11400
      Florida Apple Mac Pros
      Participant
        • Topics 2
        • Replies 11
        • Total 13
        • New Member

        I think he is either turning light out, or removing some of the light.

        #11580
        Anterweb
        Participant
          • Topics 2
          • Replies 2
          • Total 4
          • New Member

          Hi, I just popped in here to ask this exact question after watching Alex apply flux then say, let me just remove that glare, I’m having the exact same problem perfect scope view until I apply flux then I have so much glare from the ring light on my scope I really find it hard to see what I’m doing, any help or advice with this would B much appreciated.

          #11853
          Juice
          Participant
            • Topics 2
            • Replies 12
            • Total 14
            • New Member

            You need different light sources. When he says lets remove the glare he is turning off a light source aka his ring lamp on his microscope.

            I hope that helps you.


            I hope you fluxing fix that.

            #12378
            NorthridgeFix
            Keymaster
              • Topics 0
              • Replies 67
              • Total 67
              • Admin

              I’m planning a video about this topic. I will update the post when video is up.

              #13288
              Juice
              Participant
                • Topics 2
                • Replies 12
                • Total 14
                • New Member

                Really Is that a canned answer?


                I hope you fluxing fix that.

                #17562
                Marc Lewis
                Participant
                  • Topics 2
                  • Replies 5
                  • Total 7
                  • New Member

                  Hi Anterweb. I’m no pro at this but my AmScope has a 4 zone ring light wieh a little controller where you can turn on or off any of or all 4 sets of LEDs in the ring. When I’ve got a board wet with flux or cleaner, sometimes I have to switch off certain groups of LEDs to be able to see w/o the “glare” covering everything up. If you’re interested I believe the Amscope light is something like model LED-144A if I recall correctly. Otherwise, you may have to experiment a bit with perhaps shining a light from the side or something to get around that glare problem. Hope this helps!


                  All the best,
                  Marc

                Viewing 7 posts - 1 through 7 (of 7 total)
                • You must be logged in to reply to this topic.