Hi Anterweb. I’m no pro at this but my AmScope has a 4 zone ring light wieh a little controller where you can turn on or off any of or all 4 sets of LEDs in the ring. When I’ve got a board wet with flux or cleaner, sometimes I have to switch off certain groups of LEDs to be able to see w/o the “glare” covering everything up. If you’re interested I believe the Amscope light is something like model LED-144A if I recall correctly. Otherwise, you may have to experiment a bit with perhaps shining a light from the side or something to get around that glare problem. Hope this helps!
